MD-1003 factory manufactured wax heater

1.wax heater for Deep Cleansing, Exfoliators,skin rejuvenation... 2.2.for hand and facial care 3.skin will be soft and glossy

wax heater

Please read carefully this specification before use.  

 Warning:

Whenever and wherever and electric apparatus is used, especially when there are children nearby, attention should be paid to the following:  

1.   Immediately unplug the power from the power outlet after exhausted. (Attention: you must be used with a leak proof electrical outlet protection switch).

2. Do not used and stored in the bathroom or other damp places.

3. Do not be used in any way to extend the power cord.

4. The user can not leave the machine when plug in the power plug, and to supervise children shall not be closer to it.

5. Do not invasive water or other liquids.If it accidentally fall into the water, don’t close to the water or touch this machine, you need to unplug the power and far away from power outlet.  

 Operation:   How to add wax and heat

1.

 The machine will be placed in a stable heat-resistant desktop,then shrink-wrap the wax and crack into small pieces that is package by plastic bags and special used in this machine, Open the lid of the machine, put the small pieces wax into this containers.

2.

 Plug the power plug into the power outlet that will be fit for the voltage (the logo was put on the bottom of the machine) after check and confirm the switch is pointed to “off”, close the lid to keep away from dust and keep temperature, put the switch point to “HI”, the red light and green light will be on, that is to say this machine is already connected power and heat wax. You can do the physical therapy after closing the lid ,heat wax about 90 minutes and have a suitable temperature.(red light is power direction,green light is working direction,this machine will be stop heating automatically when the temperature reach your setup ,and the green light will be off at the same time )

3. 

The surface of heated wax will be not higher than “XAM” line, also can not be lower than “NIM” line,it should keep between two line .  

Voltage	AC 110v/220v 50hz/60hz
Tempreature	Melting: 65°C Keep, Warm: 55°C
Power	150W
Net Weight	1.2KGS
Gross Weight	1.4KGS

MD-1003 factory manufactured wax heater